PERFORMANCE SPECIFICATIONS PARAMETERSUNITSKXCJK-1013CONDITIONRange g±2.0, ±4.0, ±8.0User-selectable full-scale output rangeSensitivity1counts/g 64, 32, 168-bit1024, 512, 25612-bit1024 typical14-bit20g Offset vs. Tempmg/°C±0.2typical-40°C to +85°C Sensitivity vs. Temp %/°C ±0.03 typical-40°C to +85°C Mechanical Resonance3Hz3500 (xy) 1800 (z) typical-3dBOutput Data Rate (ODR)4Hz0.781 min; 50 typical; 1600 maxBandwidth(-3dB)5Hz800RES = 0ODR/2RES = 1Non-Linearity% of FS0.6typical % of full scale outputCross-axis Sensitivity%2.0 typicalI2C Communication RateMHz3.4 maxPower SupplyV2.6 typical1.8V –3.6VCurrent Consumption6μA135typicalHigh resolution (RES = 1)10 typicalLow resolution (RES = 0)0.9typicalDisabledENVIRONMENTAL SPECIFICATIONSPARAMETERSUNITSKXCJK-1013CONDITIONOperating Temperature °C -40 to 85Powered Storage Temperature°C-55 to 150Un-poweredMechanical Shockg5,000, 0.5 ms 10,000, 0.2 msPowered or un-powered,halversineESDV2,000Human body modelNOTES1Resolution and acceleration ranges are user selectable via I2C.214-bit Resolution is only available for registers 0x06h –0x0Bh in the 8g Full Power mode.3Resonance as defined by the dampened mechanical sensor.4User selectable through I2C.5User selectable; dependent on ODR and RES.6 Current varies with Output Data Rate (ODR).The performance parameters below are programmed and tested at 2.6volts and T = 25°C.The device can accept supply voltages from 1.8V to 3.6V.Due to internal voltage regulators, there should be minimal change with supply voltage variations.KXCJKAccelerometer3x3x0.9mm, 16-pin, Low-Power Accelerometer
NOTES1Resolution and acceleration ranges are user selectable via I2C.214-bit Resolution is only available for registers 0x06h –0x0Bh in the 8g Full Power mode.3Resonance as defined by the dampened mechanical sensor.4User selectable through I2C.5User selectable; dependent on ODR and RES.6 Current varies with Output Data Rate (ODR).The performance parameters below are programmed and tested at 2.6volts and T = 25°C.The device can accept supply voltages from 1.8V to 3.6V.Due to internal voltage regulators, there should be minimal change with supply voltage variations.KXCJKAccelerometer3x3x0.9mm, 16-pin, Low-Power Accelerometer